Filter
Top Products
20-11
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter Software Configuration Guide
OL-12189-01
Chapter 20 Configuring Flex Links and the MAC Address-Table Move Update Feature
Monitoring Flex Links and the MAC Address-Table Move Update Information
To disable the MAC address-table move update feature, use the no mac address-table move update
receive configuration command. To display the MAC address-table move update information, use the
show mac address-table move update privileged EXEC command.
This example shows how to configure a switch to get and process MAC address-table move update
messages:
Switch# configure terminal
Switch(conf)# mac address-table move update receive
Switch(conf)# end
Monitoring Flex Links and the MAC Address-Table Move
Update Information
Table 20-1 shows the privileged EXEC commands for monitoring the Flex Links configuration and the
MAC address-table move update information.
Step 3
end Return to privileged EXEC mode.
Step 4
show mac address-table move update Verify the configuration.
Step 5
copy running-config startup config (Optional) Save your entries in the switch startup
configuration file.
Command Purpose
Table 20-1 Flex Links and MAC Address-Table Move Update Monitoring Commands
Command Purpose
show interface
[interface-id] switchport
backup
Displays the Flex Link backup interface configured for an interface or
all the configured Flex Links and the state of each active and backup
interface (up or standby mode).
show mac address-table
move update
Displays the MAC address-table move update information on the
switch.