Filter
Top Products
39-27
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter Software Configuration Guide
OL-12189-01
Chapter 39 Configuring IPv6 Host Functions and Unicast Routing
Displaying IPv6
To disable an OSPF routing process, use the no ipv6 router ospf process-id global configuration
command. To disable the OSPF routing process for an interface, use the no ipv6 ospf process-id area
area-id interface configuration command.
For more information about configuring OSPF routing for IPv6, see the “Implementing OSPF for IPv6”
chapter in the Cisco IOS IPv6 Configuration Library at this URL:
http://www.cisco.com/en/US/products/sw/iosswrel/ps5187/products_configuration_guide_chapter0918
6a00801d660d.html
Displaying IPv6
Table 39-7 shows the privileged EXEC commands for monitoring IPv6 on the switch.
Table 39-8 shows the privileged EXEC commands for showing IPv4 and IPv6 address types on the switch.
Table 39-7 Commands for Monitoring IPv6
Command Purpose
show ipv6 access-list Display a summary of access lists.
show ipv6 cef
1
1. This command is not supported on the Catalyst Switch Module 3012.
Display Cisco Express Forwarding for IPv6.
show ipv6 interface interface-id Display IPv6 interface status and configuration.
show ipv6 mtu Display IPv6 MTU per destination cache.
show ipv6 neighbors Display IPv6 neighbor cache entries.
show ipv6 ospf
1
Display IPv6 OSPF information.
show ipv6 prefix-list Display a list of IPv6 prefix lists.
show ipv6 protocols
1
Display IPv6 routing protocols on the switch.
show ipv6 rip
1
Display IPv6 RIP routing protocol status.
show ipv6 route
1
Display the IPv6 route table entries.
show ipv6 routers
1
Display the local IPv6 routers.
show ipv6 static Display IPv6 static routes.
show ipv6 traffic Display IPv6 traffic statistics.
Table 39-8 Commands for Monitoring IPv6
Command Purpose
show ip http server history Display the previous 20 connections to the HTTP server, including the IP
address accessed and the time when the connection was closed.
show ip http server connection Display the current connections to the HTTP server, including the local and
remote IP addresses being accessed.
show ip http client connection Display the configuration values for HTTP client connections to HTTP
servers.
show ip http client history Display a list of the last 20 requests made by the HTTP client to the server.