Filter
Top Products
3-4
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Card Installation Guide
78-17406-01
Chapter 3 T1 and E1 Feature Cards
Online Installation and Removal of the T1 or E1 Feature Card
Figure 3-5 Slot Numbering on the Cisco AS5400XM Chassis
Step 2
Initialize the software busyout procedure by entering the busyout command:
Router# busyout slot-number
Step 3 Check busyout status for the slot, by entering the show busyout command.
Router# show busyout slot-number
Step 4 You can use the clear port command to immediately disable active calls on a universal port, dial-only,
or voice feature card. For more information on the universal port or dial-only feature card, see Chapter 5,
“Universal Port and Dial-Only Feature Cards.” For more information on the voice feature card, see
Chapter 6, “Voice Feature Card.” Use the show controller command to show the card that is associated
with the T1 or E1 feature card.
Router# show controller t1/e1 slot-number/control-number timeslot timeslot-number
Router# clear port slot-number/port number
Note The clear port command applies only to universal port, dial-only, or voice feature cards.
Step 5 Verify that the OK/MAINT LED is off; this indicates that the feature card is offline and ready to be
removed.
Note The OK/MAINT LED is green before you enter the busyout command. After you enter the
busyout command, the LED changes to yellow. The LED turns off after all calls are
disconnected and resources are taken out of service, indicating that busyout is complete.
Step 6 Attach an ESD-preventive wrist strap.
Warning
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Statement 1001
Step 7 Disconnect all interface cables from the feature card and secure them out of the way.
Step 8 Loosen the two captive screws that secure the feature card to the chassis until each screw is free of the
chassis. (See Figure 3-6 and Figure 3-7.)
34977
Slot 1Slot 0
Slot 2
Slot 4
Slot 6
Slot 3
Slot 5
Slot 7