Filter
Top Products
5-8
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Card Installation Guide
78-17406-01
Chapter 5 Universal Port and Dial-Only Feature Cards
Online Insertion and Removal of the Universal Port or Dial-Only Feature Card
Router# show chassis slot 3
Slot 3:
DFC type is NP108 DFC
OIR events:
Number of insertions = 1, Number of removals = 1
DFC State is DFC_S_OPERATIONAL
Installing the Universal Port or Dial-Only Feature Card
Warning
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Statement 1001
Note When you replace a feature card with a new feature card of the same type in the same slot, the system
software recognizes the new feature card and brings up the trunk interfaces automatically. If you replace
the existing feature card with a new feature card of a different type, you must reconfigure the system.
For configuration details, see the Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software
Configuration Guide.
To install the universal port or dial-only feature card, follow these steps:
Step 1 Attach an ESD-preventive wrist strap.
Step 2 Slide the feature card into the slot until the connector pins make contact with the carrier card backplane
connector. (See Figure 5-9 and Figure 5-10.)
Figure 5-9 Installing the Universal Port or Dial-Only Feature Card in the Cisco AS5350XM
Universal Gateway
36820