Filter
Top Products
6-7
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Card Installation Guide
78-17406-01
Chapter 6 Voice Feature Card
Online Insertion and Removal of the Voice Feature Card
OIR events:
Number of insertions = 0, Number of removals = 1
DFC State is DFC_S_REMOVED
Installing the Voice Feature Card
Warning
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Statement 1001
Note When you replace a feature card in a slot with a new feature card of the same type, the system software
recognizes the new feature card and brings up the trunk interfaces automatically. If you replace the
existing feature card with a new feature card of a different type, you must reconfigure the system. For
configuration details, see the Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software
Configuration Guide.
To install the voice feature card, follow these steps:
Step 1 Attach an ESD-preventive wrist strap.
Step 2 Slide the feature card into the slot until the connector pins make contact with the carrier card backplane
connector. (See Figure 6-9 and Figure 6-10.)
Figure 6-9 Installing a Feature Card in the Cisco AS5350XM Universal Gateway
Figure 6-10 Installing a Feature Card in the Cisco AS5400XM Universal Gateway
Step 3
Align the captive screws with their holes, and then seat the card completely.
Step 4 Seat the feature card in the carrier by pushing the card firmly until the captive screws are aligned with
their holes.
Step 5 Tighten the screws to secure the feature card to the chassis. (See Figure 6-11 and Figure 6-12.)
36820
37201