Filter
Top Products
5-4
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Card Installation Guide
78-17406-01
Chapter 5 Universal Port and Dial-Only Feature Cards
Online Insertion and Removal of the Universal Port or Dial-Only Feature Card
Figure 5-2 Slot Numbering on the Cisco AS5350XM Chassis
Figure 5-3 Slot Numbering on the Cisco AS5400XM Chassis
Step 2
Initialize the software busyout procedure by entering the busyout command:
Router# busyout slot-number
Step 3 To check busyout status for the slot, enter the show busyout command:
Router# show busyout slot-number
Step 4 You can use the clear port command to immediately disable active calls on a universal port or dial-only
feature card.
Router# clear port slot-number/port number
Step 5 Verify that the OK/MAINT LED is off; this indicates that the feature card is offline and ready to be
removed.
Note The OK/MAINT LED is green before you enter the busyout command. After you enter the
busyout command, the LED changes to yellow. The LED turns off after all calls are
disconnected and resources taken out of service, indicating that busyout is complete.
Step 6 Attach an ESD-preventive wrist strap.
Warning
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Statement 1001
Step 7 Loosen the two captive screws that secure the feature card to the chassis until each screw is free of the
chassis. (See Figure 5-4 and Figure 5-5.)
36006
Slot 2
Slot 0
Slot 1
Slot 3
34977
Slot 1Slot 0
Slot 2
Slot 4
Slot 6
Slot 3
Slot 5
Slot 7