3-15
Cisco AS5350XM Universal Gateway Chassis Installation Guide
OL-6417-02
Chapter 3 Installing the Cisco AS5350XM Universal Gateway
Supplying Power
Figure 3-16 Connecting the AC Power Cord
Figure 3-17 Connecting the AC Power Cord to the Redundant Power Supply
Step 3
Step 4
Power up the universal gateway.
The internal power supply fan should power up.
Wiring the DC Power Supply
If you ordered the Cisco AS5350XM universal gateway with a DC power supply, follow the procedure
in this section to wire the terminal block.
Note The grounding architecture for the Cisco AS5350XM universal gateway is isolated DC return (DC-I).
Warning
Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Statement 1003
Warning
Before connecting or disconnecting ground or power wires to the chassis, ensure that power is
removed from the DC circuit. To ensure that all power is OFF, locate the circuit breaker on the panel
board that services the DC circuit, switch the circuit breaker to the OFF position, and tape the switch
handle of the circuit breaker in the OFF position.
Statement 140
35678
Power switch
82079
Power cables
