Filter
Top Products
2-18
Cisco MDS 9100 Series Hardware Installation Guide
OL-16187-01
Chapter 2 Installing the Cisco MDS 9100 Series
Installing the Switch in a Cabinet with Insufficient Front Clearance
Note When installing the Cisco MDS 9134 Switch or the Cisco MDS 9124 Switch rear-facing into a
cabinet, do not install it higher than RU-30.
a. Route the power cord through the open cutout at the end of one of the slider rails, and then let the
cord dangle while you proceed with the next steps. Figure 2-15 shows a power cord correctly routed
through the open cutout in the slider rail.
b. Position one of the slider rails against the front rack-mounting rails and align the screw holes as
shown in Figure 2-13. Then attach them using two 12-24 screws or two 10-32 screws, depending on
the rack rail thread type. For racks with square holes, first install the 12-24 cage nuts.
c. Repeat with the other slider rail on the other front side of the rack.
d. Use the tape measure and level to verify that the rails are horizontal and at the same height.
Figure 2-13 Installing the Notched Slider Rails to the Front Rack-Mounting Rails
182462