Filter
Top Products
6-23
Multiprocessor WAN Application Module User Guide
OL-4858-07
Chapter 6 Command Reference
Command Details
reload
To reload processors on an MWAM, use the reload command available at the PC complex (processor 1
on the MWAM).
reload {processor processor_number | complex complex_number | all}
Syntax Description
Defaults There are no default behavior or values.
Command Modes PC command
Command History
Usage Guidelines Use this command when you want to reload MWAM processors or complexes. When you reload a single
processor, the other processor on the complex will also reload. See Table 1-1 for processor-to-complex
mapping.
Note You must first establish a session to processor 1 (session slot command).
Examples The following examples illustrate the reload command.
This example reloads processors 4 and 5 on complex 2 of the MWAM in slot 9:
root@mwam-9#reload complex 2
This example also reloads processors 4 and 5 on complex 2 of the MWAM in slot 9:
root@mwam-9#reload processor 4
This example reloads processors 2-6 of the MWAM in slot 9:
root@mwam-9#reload all
processor
processor_number
Specifies a processor (2-6) on the MWAM.
Note Even though only one processor is specified, both processors on the
complex will reload.
complex
complex_number
Specifies a complex (0, 1, 2, or all) on the MWAM.
all Specifies all processors on the MWAM.
Release Modification
12.3(3)B1 This command was introduced.