Filter
Top Products
6-4
Multiprocessor WAN Application Module User Guide
OL-4858-07
Chapter 6 Command Reference
Command Details
mwam module vlan-based
To assign MWAM traffic to a VLAN QoS policy, use the mwam module vlan-based command in global
configuration mode. To remove this configuration, use the no form of the command.
mwam module slot_number port port_number vlan-based
no mwam module slot_number port port_number vlan-based
Syntax Description
Defaults There are no default behavior or values.
Command Modes Global configuration.
Command History
Usage Guidelines Use this command to assign MWAM traffic to a VLAN QoS policy.
See Figure 1-1 and Table 1-1 to determine which port corresponds to each processor.
Examples The following example illustrates the mwam module vlan-based command:
Sup-7606(config)# mwam module 5 port 1 vlan-based
Sup-7606(config)# mwam module 5 port 2 vlan-based
Sup-7606(config)# mwam module 5 port 3 vlan-based
slot_number Specifies the slot that the module is plugged into.
port_number Specifies one of three switch fabric interface ports (1-3) that connect the
Supervisor module to the MWAM.
Release Modification
12.2(14)ZA7 This command was introduced.