Filter
Top Products
6-7
Multiprocessor WAN Application Module User Guide
OL-4858-07
Chapter 6 Command Reference
Command Details
show mwam module
To display connectivity information about the individual processors on the MWAM, use the show mwam
module command in privileged EXEC mode.
show mwam module slot_number port port_number {state | traffic}
Syntax Description
Defaults There are no default behavior or values.
Command Modes EXEC mode.
Command History
Examples The following example illustrates the show mwam module command:
Sup-7606#sho mwam mod 7 port 1 state
Mwam module 7 data-port 1:
Switchport: Enabled
Administrative Mode: trunk
Operational Mode: trunk
Administrative Trunking Encapsulation: dot1q
Operational Trunking Encapsulation: dot1q
Negotiation of Trunking: Off
Access Mode VLAN: 1 (default)
Trunking Native Mode VLAN: 1 (default)
Trunking VLANs Enabled: 1-999
Pruning VLANs Enabled: 2-1001
Vlans allowed on trunk:1-999
Vlans allowed and active in management domain:1,3,11-12,17,60
Vlans in spanning tree forwarding state and not pruned:
1,3,11-12,17,60
Allowed-vlan : 1-999
Sup-7606#sho mwam mod 7 port 1 traffic
Specified interface is up line protocol is up
Hardware is C6k 1000Mb 802.3, address is 0010.7b00.0cb0 (bia 0010.7b00.0cb0)
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s
Last input never, output never, output hang never
slot_number Displays the slot that the module is plugged into.
port port_number Displays the actual port number (1-3) used to connect to a processor
complex within an MWAM (Figure 1-1).
state Displays the interface status.
traffic Displays the interface statistics.
Release Modification
12.2(9)ZA This command was introduced.