Filter
Top Products
Chapter 4
Advanced Configuration
46
4-Port SSL/IPSec VPN Router
Select how you want to define the access control of this
community.
Basic
Access Mode This allows both v1 and v2c operation
requests. Select Read Only if you want the user to have
read-only access to the parameters of the MIB tree with
respect to the view name.
Select Read Write if you want the user to have read/write
access to the parameters of the MIB tree with respect to
the view name.
Select SNMP Admin if you want the user to have full
access to parameters of the MIB tree.
View Name Select View Name and then select the
appropriate MIB OID. If View Name is not selected, the
option, default, will be assigned.
Advanced
Group Name Select a group, either v1 or v2c, to assign to
this community.
Click Add to List, and configure as many entries as you
would like, up to a maximum of 15.
Base Table
The basic entries are listed. To delete an entry, select it and
click Delete.
Advanced Table
The advanced entries are listed. To delete an entry, select
it and click Delete.
Click Save Settings to save your changes, or click Cancel
Changes to undo them.
SNMP > Notification Recipient
Define the types and frequencies of the notifications.
SNMP > Notification Recipient
Notification Recipient
Recipient IP Enter the IP address that will receive the
SNMP traps.
Notification Type Select the appropriate type, Trap or
Inform. An Inform type requires response, while a Trap
type does not.
UDP Port Enter the destination port number. The default
is 162.
Timeout If you selected Inform as the Notification Type,
then enter the number of seconds the Router waits before
re-sending an inform request. The default is 15 seconds.
Retries If you selected Inform as the Notification Type,
then enter the number of tries you want the Router to re-
send an inform request. The default is 3.
SNMPv1,2
Select this option if you want to use a v1 or v2 trap. If you
selected Inform as the Notification type, this option will
not be available (v1 does not use inform requests).
Then configure the following:
Community String Enter the password used to
authenticate the management station to the Router.
Notification Version Select the appropriate version,
SNMPv1 or SNMPv2.