Filter
Top Products
91
Configuration of Multiple Subnets
4-Port SSL/IPSec VPN Router
Appendix K
Appendix K:
Configuration of Multiple
Subnets
Overview
The 4-Port SSL/IPSec VPN Router (model number: RVL200)
can support multiple subnets. The configuration example
shows an RVL200 deploying two routers.
Any router can be deployed; however, this example uses
the Linksys 10/100 4-Port VPN Router (model number:
RV042).
RVL200-to-RV042 Configuration
To create this configuration, you create two subnets and
two static routes on the RVL200. Then on each RV042, you
set it to Router mode, disable the firewall, and set up a
static route.
RVL200 Configuration
Physically connect a numbered port (Ethernet 1-4) on
the RVL200 to the WAN 1 port of the RV042.
Access the web-based utility of the RVL200. (Refer to
“Chapter 4: Advanced Configuration” for details.)
Click the Setup tab.
1.
2.
3.
RVL200 with Multiple Subnets
RVL200
LAN IP: 192.168.1.1
Multiple Subnet
IP: 192.168.7.0/24
Multiple Subnet
IP: 192.168.20.0/24
Static Route #1
Destination IP: 192.168.7.0
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.1.2
Interface: LAN
Static Route #2
Destination IP: 192.168.20.0
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.1.20
Interface: LAN
RV042 #2
WAN IP: 192.168.1.20
LAN IP: 192.168.20.254
Working Mode: Router
Firewall: Disabled
RV042 #1
WAN IP: 192.168.1.2
LAN IP: 192.168.7.254
Working Mode: Router
Firewall: Disabled
Static Route
Destination IP: 192.168.20.0
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.1.20
Interface: WAN1
Static Route
Destination IP: 192.168.7.0
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.1.2
Interface: WAN1
192.168.7.x
192.168.20.x
Default VLAN1
192.168.1.x