Filter
Top Products
DescriptionName
The data rate limit for traffic on this vHBA, in Mbps.
If you want this vHBA to have an unlimited data rate, select OFF.
Otherwise, click the second radio button and enter an integer between
1 and 10,000.
This option cannot be used in NIV
mode.
Note
Rate Limit field
The order in which this vHBA will be used.
To let the system set the order, select ANY. To specify an order, select
the second radio button and enter an integer between 0 and 17.
PCIe Device Order field
The error detect timeout value (EDTOV), which is the number of
milliseconds to wait before the system assumes that an error has
occurred.
Enter an integer between 1,000 and 100,000. The default is 2,000
milliseconds.
EDTOV field
The resource allocation timeout value (RATOV), which is the number
of milliseconds to wait before the system assumes that a resource cannot
be properly allocated.
Enter an integer between 5,000 and 100,000. The default is 10,000
milliseconds.
RATOV field
The maximum size of the Fibre Channel frame payload bytes that the
vHBA supports.
Enter an integer between 256 and 2112.
Max Data Field Size field
The channel number that will be assigned to this vHBA.
Enter an integer between 1 and 1,000.
NIV mode is required for this
option.
Note
Channel Number field
The port profile that should be associated with the vHBA, if any.
This field displays the port profiles defined on the switch to which this
server is connected.
NIV mode is required for this
option.
Note
Port Profile drop-down list
Step 9
In the Error Recovery area, update the following fields:
DescriptionName
If checked, the system uses FCP Sequence Level Error Recovery
protocol (FC-TAPE).
Enable FCP Error Recovery
check box
Cisco UCS C-Series Servers Integrated Management Controller GUI Configuration Guide, Release 1.4
OL-23489-08 13
Managing Network Adapters
Modifying vHBA Properties