Filter
Top Products
Rebuilding Persistent Bindings
Procedure
Step 1
In the Navigation pane, click the Server tab.
Step 2
On the Server tab, click Inventory.
Step 3
In the Inventory pane, click the Network Adapters tab.
Step 4
In the Adapter Cards area, select the adapter card.
If the server is powered on, the resources of the selected adapter card appear in the tabbed menu below the
Adapter Cards area.
Step 5
In the tabbed menu below the Adapter Cards area, click the vHBAs tab.
Step 6
In the Host Fibre Channel Interfaces area, select a vHBA from the table.
Step 7
Click Persistent Bindings to open the Persistent Bindings dialog box for the selected vHBA.
Step 8
In the Persistent Bindings dialog box for the selected vHBA, click Rebuild Persistent Bindings.
Step 9
Click Close.
Managing vNICs
Guidelines for Managing vNICs
When managing vNICs, consider the following guidelines and restrictions:
• The Cisco UCS P81E Virtual Interface Card and Cisco UCS VIC1225 Virtual Interface Card provide
two default vNICs (eth0 and eth1). You can create up to 16 additional vNICs on these adapter cards.
If Network Interface Virtualization (NIV) mode is enabled for the adapter, you must
assign a channel number to a vNIC when you create it.
Note
• After making configuration changes, you must reboot the host for settings to take effect.
Cisco UCS C-Series Servers Integrated Management Controller GUI Configuration Guide, Release 1.4
20 OL-23489-08
Managing Network Adapters
Rebuilding Persistent Bindings