Filter
Top Products
DescriptionName
The WWPN associated with the vHBA.
To let the system generate the WWPN, select AUTO. To specify a
WWPN, click the second radio button and enter the WWPN in the
corresponding field.
World Wide Port Name field
If checked, the vHBA can be used to perform a SAN boot.FC SAN Boot check box
If checked, any LUN ID associations are retained in memory until they
are manually cleared.
Enable Persistent LUN Binding
check box
The uplink port associated with the vHBA.
This value cannot be changed for the system-defined vHBAs
fc0 and fc1.
Note
Uplink Port field
The MAC address associated with the vHBA.
To let the system generate the MAC address, select AUTO. To specify
an address, click the second radio button and enter the MAC address in
the corresponding field.
MAC Address field
If there is no default VLAN for this vHBA, click NONE. Otherwise,
click the second radio button and enter a VLAN ID between 1 and 4094
in the field.
Default VLAN field
The CoS for the vHBA.
Select an integer between 0 and 6, with 0 being lowest priority and 6
being the highest priority.
This option cannot be used in NIV
mode.
Note
Class of Service drop-down list
The data rate limit for traffic on this vHBA, in Mbps.
If you want this vHBA to have an unlimited data rate, select OFF.
Otherwise, click the second radio button and enter an integer between
1 and 10,000.
This option cannot be used in NIV
mode.
Note
Rate Limit field
The order in which this vHBA will be used.
To let the system set the order, select ANY. To specify an order, select
the second radio button and enter an integer between 0 and 17.
PCIe Device Order field
The error detect timeout value (EDTOV), which is the number of
milliseconds to wait before the system assumes that an error has
occurred.
Enter an integer between 1,000 and 100,000. The default is 2,000
milliseconds.
EDTOV field
Cisco UCS C-Series Servers Integrated Management Controller GUI Configuration Guide, Release 1.4
8 OL-23489-08
Managing Network Adapters
Viewing vHBA Properties