Filter
Top Products
DescriptionName
The firmware version that is currently active.Running Version field
The alternate firmware version installed on the adapter, if any. The
backup version is not currently running. To activate it, administrators
can click Activate Firmware in the Actions area.
When you install new firmware on the adapter, any existing
backup version is deleted and the new firmware becomes the
backup version. You must manually activate the new firmware
if you want the adapter to run the new version.
Note
Backup Version field
The firmware version that will become active the next time the adapter
is rebooted.
Startup Version field
The bootloader version associated with the adapter card.Bootloader Version field
The status of the last firmware activation that was performed on this
adapter.
The status is reset each time the adapter is
rebooted.
Note
Status field
What to Do Next
To view the properties of virtual NICs, VM FEXs, and virtual HBAs, see the following sections:
• Viewing vNIC Properties, on page 21
• Viewing Virtual FEX Properties, on page 31
• Viewing vHBA Properties, on page 7
Configuring Adapter Properties
Before You Begin
• You must log in with admin privileges to perform this task.
• A supported Virtual Interface Card (VIC) must be installed in the chassis and the server must be powered
on.
Cisco UCS C-Series Servers Integrated Management Controller GUI Configuration Guide, Release 1.4
OL-23489-08 5
Managing Network Adapters
Configuring Adapter Properties