Filter
Top Products
DescriptionName
The resource allocation timeout value (RATOV), which is the number
of milliseconds to wait before the system assumes that a resource cannot
be properly allocated.
Enter an integer between 5,000 and 100,000. The default is 10,000
milliseconds.
RATOV field
The maximum size of the Fibre Channel frame payload bytes that the
vHBA supports.
Enter an integer between 256 and 2112.
Max Data Field Size field
The channel number that will be assigned to this vHBA.
Enter an integer between 1 and 1,000.
NIV mode is required for this
option.
Note
Channel Number field
The port profile that should be associated with the vHBA, if any.
This field displays the port profiles defined on the switch to which this
server is connected.
NIV mode is required for this
option.
Note
Port Profile drop-down list
Step 9
In the Error Recovery area, review the information in the following fields:
DescriptionName
If checked, the system uses FCP Sequence Level Error Recovery
protocol (FC-TAPE).
Enable FCP Error Recovery
check box
The number of milliseconds the uplink port should be offline before it
informs the system that the uplink port is down and fabric connectivity
has been lost.
Enter an integer between 0 and 240,000.
Link Down Timeout field
The number of times an I/O request to a port is returned because the
port is busy before the system decides the port is unavailable.
Enter an integer between 0 and 255.
Port Down I/O Retries field
The number of milliseconds a remote Fibre Channel port should be
offline before informing the SCSI upper layer that the port is unavailable.
Enter an integer between 0 and 240,000.
Port Down Timeout field
Step 10
In the Fibre Channel Interrupt area, review the information in the following fields:
Cisco UCS C-Series Servers Integrated Management Controller GUI Configuration Guide, Release 1.4
OL-23489-08 9
Managing Network Adapters
Viewing vHBA Properties