Filter
Top Products
5
Before Installing TP Desktop Connector
Software
This chapter describes the preparations and requirements necessary
for installing Compaq TP Desktop Connector software and also contains
information on removing TP Desktop Connector software from Windows
platforms. Your bill of materials (BOM) specifies the number and contents
of your distribution media. Be sure to verify the contents of your kit with
this information. If your kit is damaged or incomplete, contact your Compaq
representative.
5.1 Installation Overview
The TPware Product Suite CD contains all the software required for
development or deployment of TP Desktop Connector client applications.
The gateway software needed to connect to an ACMS system is included
on a separate CD included in the distribution kit. The gateway software
installation is described in Part III. Chapter 4 describes the contents of the
TPware Product Suite CD.
For a list of the client platforms supported by the TP Desktop Connector
product, see the TP Desktop Connector Software Product Description.
If you are developing TP Desktop Connector client applications for a non-
Windows system, you must install the client services files yourself (proceed to
Chapter 7.
5.2 Preparing to Install TP Desktop Connector Software
Ensure that your system meets the software requirements. Minimum software
requirements needed to install the TP Desktop Connector software and build
client applications that run with ACMS systems are shown in the Software
Product Description (SPD), a copy of which is included in the product kit.
You must have a Windows operating system with a CD drive on which to run
the installation procedures that are described in Chapter 6.
Before Installing TP Desktop Connector Software 5–1