Filter
Top Products
11.2.2 IVP Steps
To run the IVP independently of the installation procedure, follow these steps:
1. Log in to the SYSTEM account:
Username: SYSTEM
Password:
2. Set your default to the test directory:
$ SET DEFAULT SYS$TEST
$
3. Run the IVP using the following file specification:
ACMSDI$IVP.COM
You can run the IVP only on your current booted system. You cannot run
the IVP over a networked connection.
To start the IVP, enter the following command:
$ @ACMSDI$IVP
The TP Desktop Connector V3.2 Gateway for ACMS IVP completed successfully
.
.
.
The TP Desktop Connector V3.2 Gateway for ACMS IVP completed successfully
The IVP takes no more than 30 seconds to run, depending on the current
system load.
11.2.3 IVP Error Recovery
As the IVP executes, it checks the success of each test and operation it
performs. If any test or operation fails, the IVP does the following:
1. Stops processing.
2. Displays a message describing the failure.
3. Suggests a course of action to eliminate the cause of the failure.
Follow the suggested course of action and then restart the IVP.
11–2 Running the TP Desktop Connector Gateway for ACMS IVP