Filter
Top Products
If the disk has quotas enabled, a message is displayed. The account must have
sufficient disk quotas to install. Refer to Table 8–1.
9.2.4 Running the Installation Verification Procedure
If you chose to run the IVP, VMSINSTAL runs it next. When the IVP runs
successfully, you see the following messages displayed:
%RUN-S-PROC_ID, identification of created process is 210031D5
Starting Server ACMSDI$SERVER
The TP Desktop Connector V3.1A Gateway for ACMS IVP completed successfully
Installation of ACMSDI V3.1A completed at 13:32
.
.
.
The TP Desktop Connector V3.1A Gateway for ACMS IVP completed successfully
9.2.5 Completing the Installation Procedure
The following messages indicate that the installation procedure is complete:
Installation of ACMSDI V3.1A completed at 13:32
VMSINSTAL procedure done at 13:33
$
You can now log out of the privileged account:
$ LOGOUT
SYSTEM logged out at 31-AUG-1999 13:34:12.28
VMSINSTAL deletes or changes entries in the process symbol tables during
the installation. Therefore, to continue using the system account and restore
these symbols, log out and log in again. Proceed to Chapter 10 to follow
postinstallation procedures.
9.3 Recovering from System and Installation Failures
An unsuccessful installation can result from a system failure (see Section 9.3.1)
or errors encountered during the installation procedure (see Section 9.3.2).
9.3.1 System Failures
If you experience a system failure, such as a power loss during installation,
VMSINSTAL attempts to continue the installation when you reboot the system.
Depending on the point in the installation at which the system fails, one of
three conditions exists:
• The system disk did not undergo any changes before the system failure.
VMSINSTAL instructs you to restart the installation.
9–8 Installing TP Desktop Connector Gateway for ACMS Software