Filter
Top Products
System-Level Commands
26 E-Class DPL Programmer’s Manual
STX y Select Font Symbol Set
This command selects the scalable font symbol set. The selected symbol set remains active until
another symbol set is selected. See Appendices E, I, and the <STX>KS command for more
information. Option dependant. Not all symbol sets can be used with all fonts.
Syntax:
<STX>ySxx
Where: S - Byte size designation, see Appendix H.
S = Single-byte symbol sets
U = Double-byte symbol sets
xx - Symbol set selection.
Sample: <STX>ySPM
The sample selects the PC-850 multilingual set.
STX Z Print Configuration and Dot Pattern Labels
This command prints Configuration and Dot Pattern Labels. The results are similar to performing the
power-up self-test, but the printer does not enter Hex Dump Mode. To capture all printed
information, use the labels as wide as the maximum print width and at least 4 inches (102mm) long.
Syntax:
<STX>Z
Printer response:
FRI SEPTEMBER 026, 1997 19:29 244
VER: E4304 - 04.06 08/24/01
BOOT 83-2329-04A
CODE 83-2325-04F
FONT 83-2337-01A
CPLD 59-2157-01C
SYSTEM RAM CHECKS____ GOOD
SYSTEM RAM SIZE___ 2016 KBYTES
SYSTEM RAM AVAIL__ 1264 KBYTES
REG POWER SUPPLY__ NO
INPUT VALUES
PAPER_____________ 255
DARKNESS__________ 131
TRAN______________ 255
REFL______________ 149
RIBM______________ 87
THR_______________ 48
24V_______________ 223
DIRECT THERMAL
COMMUNICATIONS NOT DETECTED
9600,8,N
EDGE
SOP ADJUST________ 128
PRESENT ADJUST____ 128
TOF LOW___________ 0
TOF DELTA_________ 10
TOF GAIN__________ 10
OOS MAXVOLT_______ 2
COUNTER INFORMATION
ABSOLUTE VALUES 9-18-1999
LENGTH____ 773 INCHES
TIME______ 20 HOURS
RESETTABLE VALUES 9-22-1999
LENGTH____ 576 INCHES
TIME______ 10 HOURS
MEMORY CONFIGURATION
INTERNAL MODULE______ 128
SCALABLE FONTS_______ 64
LABEL SIZE 0410:02218 IN
STX z Pack Module
This command causes the printer to reclaim all storage space associated with all deleted files on the
specified module (see <STX>X and <STX>x).
Syntax:
<STX>zm
Where:
m
- Module designator; see Appendix J.