Filter
Top Products
Extended System Commands
E-Class DPL Programmer’s Manual 29
STX KC Get Configuration
This command returns the configuration of the printer. The form of the returned data is similar to that
of a Configuration Label. This command should be parsed by KEYWORDS, not Character
POSITIONS. Each line is terminated by a CR (0x0d) & LF (0x0a). Datamax will make every effort
to keep Keyword consistent.
Syntax:
<STX>KC<CR>
Printer response:
XXX NOT SET 00, 0000 00:22 000
VER: E4304 - 04.06 08/24/01
BOOT 83-2329-04A
CODE 83-2325-04F
FONT 83-2337-01A
CPLD 59-2157-01C
INTERNAL FLASH MODULE PRESENT
SYSTEM RAM CHECKS____ GOOD
SYSTEM RAM SIZE___ 2015 KBYTES
SYSTEM RAM AVAIL__ 1244 KBYTES
REG POWER SUPPLY__ YES
CONFIGURATION
DIRECT THERMAL
SERIAL PORT SELECTED
9600;8 BITS
EDGE
CONT FORM LENGTH__ 0
PRESENT ADJUST____ 127
SOP ADJUST________ 127
TOF LOW___________ 0 0
TOF DELTA_________ 10 10
TOF GAIN__________ 12 10
OOS MAXVOLT_______ 3 3
LABEL ALIGNMENT___ AUTO
ALIGN LENGTH______ 460
STOP LOCATION_____ PEEL
INPUT VALUES
PAPER_____________ 0
POT_______________ 255
TRAN______________ 250
REFL______________ 0
RIBN______________ 116
TEMP______________ 52
VOLT______________ 214
COUNTER INFORMATION
ABSOLUTE VALUES 1- 1-1995
LENGTH____ 2065 INCHES
TIME______ 62 HOURS
RESETABLE VALUES 1- 1-1995
LENGTH____ 2065 INCHES
TIME______ 62 HOURS
MEMORY CONFIGURATION
INTERNAL MODULE______ 15
SCALABLE FONTS_______ 32
LABEL SIZE 0416:02157 IN
END OF LIST
STX Kc Set Configuration
This command, equivalent to using other system commands followed by the <SOH>U and intended
for easily configuring a custom setup not dynamic configuration changes, specifies the Power-up
Configuration parameter values for the printer. The printer will reset upon completion of a command
stream containing parameter value (e.g., memory configuration, label width, etc.) changes; no
commands should be sent until this reset is complete. The following are highlights of this command:
• These parameter values do not affect the factory default settings of the printer.
• When separated by a semi-colon (;), multiple parameter values included in a single command
stream.
• All values are stored in Flash memory and remain in effect until new values are received or until
factory defaults are restored.
• If system commands are sent that override the Power-up Configuration value(s), the Power-up
Configuration value(s) will be restored the next time the printer is powered ‘on’ or reset.
• The parameters are the same as those found in the Setup Menu.
Note: Illegal or out of range parameter values may have unpredictable results.