Filter
Top Products
Back to Contents Page
Removing and Replacing Parts
Dell™PowerEdge™2650SystemsServiceManual
The procedures in this guide require that you remove the cover and work inside the system. While working inside the system, do not attempt to service the
system except as explained in this manual and elsewhere in your system documentation. Always follow the instructions closely. Review all of the procedures in
your System Information document.
This section provides servicing procedures for components inside the system. Before you start any of the procedures in this section, perform the following
tasks:
l Perform the procedures described in "External Visual Inspection."
When there is no replacement procedure provided, use the removal procedure in reverse order to install the replacement part.
Recommended Tools
You need the following items to perform the procedures in this section:
l Key to the system keylock
l #2 Phillips screwdriver
l Wrist grounding strap
System Orientation
The illustrations in this document are based on the positioning of the system as shown in Figure4-1.
Figure 4-1. System Orientation
Recommended Tools
System Orientation
Bezel
System Cover
Inside the System
Control-Panel Cable Cover
Front-Panel I/O Board
Control Panel
System Fans
System-Fan Bracket
Power Supplies
Expansion-Card Cage
Expansion Cards
Expansion-Card Riser Board
Memory Modules
CD and Diskettes Drives
SCSI Configuration Information
External SCSI Tape Drive
Hard Drives
Integrated RAID Controller
RAID Controller Card
SCSI Backplane Daughter Card
SCSI Backplane Board
System Board Tray
System Board Tray Levers
Microprocessors
System Battery
System Board
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See
your System Information document for complete safety information.
Read the safety information in the System Information document.