Filter
Top Products
Remote Console Switch Software Basic Operations 82
3
Click the
Network
tab and type in the address of the Remote Console
Switch. This field can contain an IP dot notation or a domain name.
Duplicate addresses are not allowed and the field cannot be left blank. You
can enter up to 128 characters, and may use an IPv4 or an IPv6 address.
4
Type the HTTP and HTTPS port numbers in the
HTTP Port
and
HTTPS
Port
fields, respectively, if you changed the port numbers for the Remote
Console Switch in the serial console. For more information on changing
the port numbers in the serial console, see "To configure the HTTP and
HTTPS ports:" on page 19.
Figure 4-11. Switch Network Properties Tab
5
Click
Apply
to save the new settings.
-or-
Click
OK
to save the new settings and close the window.
-or-
Click
Cancel
to exit without saving the new settings.