Filter
Top Products
Use To
Collate
(1,1,1) (2,2,2)
(1,2,3) (1,2,3)
Stack the pages of a print job in sequence when printing multiple copies.
Note: “(1,1,1) (2,2,2)” is the factory default setting.
Sides (Duplex)
1 sided
2 sided
Specify whether prints are on one side or on both sides of the page.
Note: 1 sided is the factory default setting.
Staple
Off
On
Specify whether prints are stapled.
Notes:
• Off is the factory default setting.
• On allows the printer to staple print jobs.
• This menu appears only when a supported staple finisher is installed.
Hole Punch
Off
On
Specify whether prints have holes for binding.
Notes:
• Off is the factory default setting.
• This menu appears only when a supported staple, hole punch finisher is
installed.
Hole Punch Mode
2 holes
3 holes
4 holes
Specify the number of holes to be made on the prints.
Notes:
• “3 holes” is the factory default setting.
• This menu appears only when a supported staple, hole punch finisher is
installed.
Duplex Binding
Long Edge
Short Edge
Define the way duplexed pages are bound and printed.
Notes:
• Long Edge assumes binding along the long edge of the page (left edge for
portrait and top edge for landscape). This is the factory default setting.
• Short Edge assumes binding along the short edge of the page (top edge for
portrait and left edge for landscape).
Paper Saver Orientation
Auto
Landscape
Portrait
Specify the orientation of a multiple‑page document.
Notes:
• Auto is the factory default setting.
• This setting affects jobs if the value of the Paper Saver setting in the same
menu is not set to Off.
Understanding printer menus 113