Filter
Top Products
Some held jobs were not restored
From the printer control panel, select Continue to clear the message and continue printing.
Note: Held jobs that are not restored remain in the printer hard disk and are inaccessible.
Standard network software error [54]
Try one or more of the following:
• From the printer control panel, press to confirm.
• Unplug the router, then wait for 30 seconds, and then plug it back again.
• Turn off the printer, and then turn it back on.
• Update the network firmware in the printer or print server. For more information, contact your system support
person.
Standard USB port disabled [56]
Try one or more of the following:
• From the printer control panel, press to clear the message and continue printing.
Note: The printer discards any data received through the USB port.
• From the printer control panel, set USB Buffer to Auto.
Supply needed to complete job
A supply needed to complete the job is missing. Cancel the current job.
Too many bins attached [58]
1 Turn off the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the extra bins.
4 Connect the power cord to a properly grounded electrical outlet.
5 Turn the printer back on.
Too many disks installed [58]
1 Turn off the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the extra printer hard disks.
4 Connect the power cord to a properly grounded electrical outlet.
5 Turn the printer back on.
Troubleshooting 187