Filter
Top Products
Understanding the Printer Menus 129
WPS Setup
Purpose:
To configure the wireless network using WPS.
Va lue s :
NOTE: WPS 2.0 compliant. WPS 2.0 works on access points with the following encryption types: Mixed mode PSK, WPA-PSK
AES, WPA2-PSK AES, WPA-PSK TKIP, Open (No Security)
NOTE: For Dell C1760nw Color Printer, this item is displayed when the Ethernet cable is disconnected and Wireless LAN is
set to Enable.
NOTE: For Dell C1660w Color Printer, this item is displayed only when Wireless LAN is set to Enable.
Reset Wireless
Purpose:
To initialize wireless network settings. After executing this function and rebooting the printer, all wireless network
settings are reset to their default values.
NOTE: For Dell C1760nw Color Printer, this item is displayed when the Ethernet cable is disconnected and Wireless LAN is
set to Enable.
NOTE: For Dell C1660w Color Printer, this item is displayed only when Wireless LAN is set to Enable.
TCP/IP
Purpose:
To configure TCP/IP settings.
The change takes effect after the printer is turned off and then on.
Va lue s :
Push Btn. Ctrl PBC Start
*1
Configures the wireless setting with the security method of WPS-PBC.
PIN Code Start Config. Configures the wireless setting using the PIN code assigned automatically
by the printer.
Print PIN Code Prints the PIN code. Confirm it when you enter the PIN code to your
computer.
*1
You can also start WPS-PBC by pressing and holding the (Wi-Fi | WPS) button.
IP Mode Dual Stack* Uses both IPv4 and IPv6 to set the IP address.
IPv4 Mode Uses IPv4 to set the IP address.
IPv6 Mode Uses IPv6 to set the IP address.
IPv4 Get IP Address AutoIP* Automatically sets the IP address.
BOOTP Uses BOOTP to set the IP address.
RARP Uses RARP to set the IP address.
DHCP Uses DHCP to set the IP address.
Panel Enables the IP address entered on the operator panel.
IP Address Manually sets the IP address allocated to the printer.
Subnet Mask Manually sets the subnet mask.
Gateway Address Manually sets the gateway address.