Filter
Top Products
4. Tighten the M2 x 3-mm screw that secures the microphone board to the display cover.
5. Replace the display bezel (see Replacing the Display Bezel (E6400 and M2400) or Replacing the Display Bezel (E6400 ATG)).
6. Replace the display assembly (see Replacing the Display Assembly (E6400 and M2400) or Replacing the Display Bezel (E6400 ATG)).
7. Replace the hinge covers (see Replacing the Hinge Covers).
8. Replace the bottom of the base assembly (see Replacing the Bottom of the Base Assembly).
9. Follow the procedures in After Working on Your Computer.
Removing the Camera and Microphone Assembly
1. Follow the instructions in Before Working on Your Computer.
2. Remove the bottom of the base assembly (see Removing the Bottom of the Base Assembly).
3. Remove the hinge covers (see Removing the Hinge Covers).
4. Remove the display assembly (see Removing the Display Assembly (E6400 and M2400) or Removing the Display Assembly (E6400 ATG)).
5. Remove the display bezel (see Removing the Display Bezel (E6400 and M2400) or Removing the Display Bezel (E6400 ATG)).
6. Lift the small connector lever on the camera/microphone cable.
7. Loosen the captive screw, and carefully lift the camera/microphone assembly up at an angle and disconnect the camera/microphone cable.
1
notch on display cover
2
microphone board
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.
1
display cover
2
camera/microphone assembly
3
captive screw
4
connector lever