Filter
Top Products
Back to Contents Page
FCM
Dell™Latitude™E6400andE6400ATGand
MobileWorkstationPrecision™M2400ServiceManual
Removing an FCM from the WWAN/FCM Slot
Removing an FCM from the WPAN/UWB/FCM Slot
Replacing an FCM
The FCM is also known as Intel®Turbo Memory and the Intel Flash Cache Logic Chip Mini-card. You can install an FCM in either the WWAN/FCM card connector
or the WPAN/UWB/FCM card connector.
Removing an FCM from the WWAN/FCM Slot
1. Follow the procedures in Before Working on Your Computer.
2. Remove the bottom of the base assembly (see Removing the Bottom of the Base Assembly).
3. Remove the M2 x 3-mm screw. The FCM pops up at a 45-degree angle.
4. Slide the FCM out of the card connector on the system board.
Removing an FCM from the WPAN/UWB/FCM Slot
1. Follow the procedures in Working on Your Computer.
2. Remove the bottom of the base assembly (see Removing the Bottom of the Base Assembly).
3. Remove the M2.5 x 5-mm screw from the left hinge cover, and slide it forward then lift to remove it.
4. Remove the M2 x 3-mm screw. The FCM pops up at a 45-degree angle.
5. Slide the FCM out of the card connector on the system.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
NOTE: This module is only compatible with the Microsoft®Windows Vista®operating system.
1
M2 x 3-mm screw
2
card connector
3
FCM