Filter
Top Products
Back to Contents Page
Hinge Covers
Dell™Latitude™E6400andE6400ATGand
MobileWorkstationPrecision™M2400ServiceManual
Removing the Hinge Covers
Replacing the Hinge Covers
Removing the Hinge Covers
The hinge covers are not interchangeable; the left one covers the DisplayPort connector and the right one covers the RJ-45 network connector.
1. Follow the procedures in Before Working on Your Computer.
2. Remove the bottom of the base assembly (see Removing the Bottom of the Base Assembly).
3. Remove the M2.5 x 5-mm screw from each hinge cover.
4. Slide each hinge cover forward and lift to remove it.
Replacing the Hinge Covers
1. Slide the left hinge cover over the DisplayPort connector and slide the right hinge cover over the RJ-45 network connector.
2. Replace the M2.5x5-mm screw in each hinge cover.
3. Replace the bottom of the base assembly (see Replacing the Bottom of the Base Assembly).
4. Follow the procedures in After Working on Your Computer.
Back to Contents Page
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
1
M2.5 x 5-mm screws (2)
2
hinge covers