Filter
Top Products
Replacing an FCM
1. Slide the FCM into the card connector on the system board.
2. Press the FCM down and hold it in place.
3. Replace the M2 x 3-mm screw.
4. Secure the wireless cables:
If you are installing the FCM in the WWAN/FCM slot, place the gray/black and gray/white antenna cables in the holder next to the module.
If you are installing the FCM in the WPAN/UWB/FCM slot, place the blue antenna cable in the holder next to the module.
1
M2 x 3-mm screw
2
card connector
3
FCM
NOTICE: When installing this module, ensure that the antenna cables are not under the card. Place the antenna cables in the holder next to the
module. Installing the module on top of these antenna cables may cause damage to your computer.
NOTICE: The connectors are keyed to ensure correct insertion. If you feel resistance, check the connectors on the module and on the system board,
and realign the module.
NOTICE: An FCM can be installed in the WWAN/FCM card connector or the WPAN/UWB/FCM card connector. Use whichever card connector is available. If
both are available, use the WWAN/FCM card connector, which is easier to access.
1
FCM
2
gray/black antenna cable
3
gray/white antenna cable
4
holder by module