Filter
Top Products
About Your System 17
Table 1-7. LCD Status Messages
Line 1
Message
Line 2
Message
Causes Corrective Actions
N/A
SYSTEM NAME
A 62-character string that can be
defined by the user in the System
Setup program.
The
SYSTEM NAME
displays
under the following conditions:
• The system is powered on.
• The power is off and active
POST errors are displayed.
This message is for information
only.
You can change the system string
in the System Setup program. See
"Using the System Setup
Program" on page 31.
E1000 FAILSAFE, Call
Support
See "Getting Help" on page 129.
E1A14 SAS Cable A SAS cable A is unseated, missing,
or bad.
Check the cable connection to
the SAS backplane. See "SAS
Backplane Board Connectors" on
page 127.
E1A15 SAS Cable B SAS cable B is unseated, missing,
or bad.
Check the cable connection to
the SAS backplane. See "SAS
Backplane Board Connectors" on
page 127.
E1114 Temp Ambient Ambient system temperature is
out of acceptable range.
See "Troubleshooting System
Cooling Problems" on page 105.
E1210 CMOS Batt CMOS battery is missing, or the
voltage is out of acceptable range.
See "Troubleshooting the System
Battery" on page 104.
E1211 ROMB Batt RAID battery is either missing,
bad, or unable to recharge due to
thermal issues.
Reseat the RAID battery. See
"Installing the SAS RAID
Controller Card Battery" on
page 76, and "Troubleshooting
System Cooling Problems" on
page 105.
E12
nn XX
PwrGd Specified voltage regulator has
failed.
See "Getting Help" on page 129.
E1229 CPU # VCORE Processor # VCORE voltage
regulator has failed.
See "Getting Help" on page 129.
E122A CPU # VTT Processor # VTT voltage has
exceeded the allowable voltage
range
See "Getting Help" on page 129.