Filter
Top Products
Installing System Components 57
Figure 3-9. RAC Card Connectors
9
Reinstall the storage controller card.
10
Reinstall the cooling shrouds. See "Replacing the Cooling Shrouds" on page 50.
11
Reconnect all cables to the storage controller card and feed the cables through the appropriate
channels and keepers on the cooling shrouds.
12
Close the system. See "Closing the System" on page 47.
13
Reconnect the system and peripherals to their power sources, and turn them on.
14
Enter the System Setup program and verify that the setting for the Boot Sequence has changed to
reflect the presence of the RAC card. See "Using the System Setup Program" in your
Hardware Owner’s
Manual
.
15
Exit the System Setup program and reboot the system.
When the system boots, the
Remote Access Control Detected
message displays and the
option ROM and firmware information for the RAC displays.
Press <Ctrl><e> to enter the RAC configuration screen. See the RAC documentation for
information on configuring and using the RAC.
System Memory
You can upgrade your system memory to a maximum of 32 GB (two-processor configurations) or 64 GB
(four-processor configurations) by installing 667-MHz registered DDR-II memory modules (DIMMs) in
sets of 512-MB, 1-GB, 2-GB, or 4-GB modules. The sixteen memory sockets are located on the system
board under the cooling shrouds. Each processor has four memory channels, organized in sets of two.
1 RJ-45 connector 2 44-pin MII cable connector 3 50-pin management cable
connector
1
3
2