Filter
Top Products
86 Installing System Components
Chassis Intrusion Switch (Service-Only Procedure)
Removing the Chassis Intrusion Switch
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the
components inside the system. See your Product Information Guide for complete information about safety
precautions, working inside the computer, and protecting against electrostatic discharge.
1
Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2
Open the system. See "Opening the System" on page 46.
3
Remove the top cooling shroud. See "Removing the Cooling Shrouds" on page 49.
4
If present, remove the heat sink from processor 4. See "Processors" on page 62.
5
Disconnect the intrusion-switch cable from its system board connector. See Figure 3-25.
6
Grasp the intrusion switch and slowly and firmly pull the switch out from the intrusion-switch clip.
Figure 3-25. Removing and Installing the Chassis Intrusion Switch
1 intrusion-switch clip 2 intrusion switch 3 grooved side (2)
4 intrusion-switch cable
4
3
1
2