Filter
Top Products
Installing System Components 127
13
Enter the System Setup program and if the time and date are still
incorrect, see "Getting Help" on page 175 for instructions on obtaining
technical assistance.
Sideplane Board
Removing the Sideplane Board
CAUTION: Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. See your Product
Information Guide for complete information about safety precautions, working
inside the computer, and protecting against electrostatic discharge.
1
Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
2
Open the system. See "Opening the System" on page 71.
3
Remove the SAS controller daughter card. See "Removing a SAS
Controller Daughter Card" on page 86.
4
Remove any cables from the sideplane board.
NOTICE: When detaching the control panel cable from the sideplane board,
squeeze the metal ends of the cable connectors and gently work the connector out
of the socket. Do not pull on the cable to unseat the connector. Doing so can
damage the cable.
5
Pressing inward on the sideplane release tabs, lift the sideplane up and
away from the system. See Figure 3-29
Installing the Sideplane Board
1
Insert the sideplane board into sideplane slots along the left wall of the
chassis and lower the sideplane board so that the pin collars connect with
the two pins on the system board. Press the sideplane down until sideplane
connector is fully seated into the system board connector. See Figure 3-29.
2
Reattach the control panel cable to the sideplane board.
3
Replace the storage controller daughter card. See "Installing a SAS
Controller Daughter Card" on page 84.
4
Close the system. See "Closing the System" on page 71.