Filter
Top Products
86 Installing System Components
Figure 3-11. SAS Controller Daughter Card Cabling
6
For battery-cached SAS RAID controllers, install the RAID battery. See
"Installing a RAID Battery" on page 87.
Removing a SAS Controller Daughter Card
1
Disconnect the SAS cable from the SAS controller daughter card.
2
Press down on the blue release tab and push the SAS controller daughter
card out of the sideplane connector. See Figure 3-10.
3
Remove the card tray from the chassis hooks and lift the card from the
system.
4
If applicable, remove the RAID battery from the battery holder.
1 SAS controller daughter card 2 SAS 0 connector
3 SAS_A connector (below BKPLN
connector)
4 SAS cable (1)
1
4
3
2