Filter
Top Products
Installing System Components 79
Figure 3-7. Removing and Installing a Power Supply
Replacing a Power Supply
1
With the power-supply handle in the extended position, slide the new
power supply into the chassis. See Figure 3-7.
2
Rotate the handle down until it is completely flush with the power-supply
faceplate and the orange snap engages. See Figure 3-7.
3
Connect the power cable to the power supply.
a
Route the power cable into the cable retention bracket from the power
supply side of the bracket (see Figure 3-7).
b
Loop the cable from the cable retention bracket up to the power plug
at the back of the power supply, and connect the cable.
1 locking tab 2 cable retention bracket
3 power-supply handle
1
3
2