Filter
Top Products
About Your System 37
Error: Incorrect
memory
configuration
CPU
n
The DIMM group for CPU n
is incorrectly configured and
caused the system to halt.
See "General Memory
Module Installation
Guidelines" on page 114 for
memory configuration
information. If the problem
persists, see
"Troubleshooting System
Memory" on page 150.
!!*** Error:
Remote Access
Controller
initialization
failure *** RAC
virtual USB
devices may not
be available...
Remote Access Controller
initialization failure
Ensure that the Remote
Access Controller is properly
installed. See "Installing a
RAC Card" on page 106.
Gate A20 failure Faulty keyboard controller;
faulty system board.
See "Getting Help" on
page 175.
General failure The operating system is
unable to carry out the
command.
This message is usually
followed by specific
information. Note the
information, and take the
appropriate action to resolve
the problem.
HyperTransport
error caused a
system reset!
Please check the
system event log
for details!
A fatal system error occurred
and caused the system to
reboot.
Check the SEL for
information that was logged
during the error. See the
applicable troubleshooting
section in "Troubleshooting
Your System" on page 137 for
any faulty components
specified in the SEL.
Invalid NVRAM
configuration,
Resource Re-
allocated
System detected and
corrected a resource conflict.
No action is required.
Table 1-7. System Messages (continued)
Message Causes Corrective Actions