Filter
Top Products
Installing System Components 87
RAID Battery
The information in this section applies only to systems with the optional
battery-cached SAS controller daughter card.
Installing a RAID Battery
1
Insert the RAID battery into the battery carrier. See Figure 3-12.
2
Locate the battery bay to the right of the SAS daughter card on top of the
hard drive bays.
3
Insert the battery carrier and RAID battery into the system’s battery carrier
slots and connect the battery cable to the storage daughter card, ensuring
that the battery carrier is aligned and fully seated in the slots.
Removing a RAID Battery
1
Disconnect the cable between the RAID battery and the SAS controller
daughter card. See Figure 3-12.
2
Press down and to the left on the battery carrier to disengage the carrier
from the chassis battery carrier slots.
3
Pull back gently on the two guides holding the RAID battery in the battery
carrier and draw out the RAID battery from the battery carrier.