Filter
Top Products
1. Firmly hold the computer and press on the release lever tab until the tab is freed from the slot on the mounting plate.
2. While still firmly holding the computer, slide the computer and stand approximately 1 inch (2.5 cm), until it stops.
3. Lower the computer and stand away from the mounting plate.
Connecting the Power Adapter
1. Connect the power adapter to the connector on the back of the computer. In order for the connection to be secure, verify that the latch engages
completely (a click will be heard or felt).
2. Connect a power cable to the power adapter.
If you decide not to connect the green ground wire to an electrical outlet, go to step4.
1
mounting plate slot
2
release lever tab
CAUTION: To avoid personal injury, remove the mounting plate if you are permanently removing the computer.
NOTICE: The following section applies to Japan only.
CAUTION: If you decide to connect the green ground wire to an electrical outlet, do not permit contact between the green ground wire and power
leads because electrical shock, fire, or damage to your computer can occur (see the following figure).