Filter
Top Products
Dialogic
®
PBX Integration Board User’s Guide
external call forwarded on ring no answer and an external call
forwarded on busy. If the Dialogic
®
PBX Integration port is not
set as the prime set, then forwarded external calls will appear as
external forwarded on no answer. Programming the Dialogic
®
PBX Integration port as prime set is shown below.
3. Assign ring only to the first port of the Dialogic
®
D/82JCT-U or
D/42JCT-U Board for lines that are to be answered by the board,
that is, direct into voice mail. For all lines that go directly to an
extension, first have them “unassigned” for the ports on the
board.
4. If lines are not being used, assign them to any pool except pool
A. This impacts out dialing.
Program the Dialogic
®
PBX Integration port as Prime Set as follows:
For Loop Start Lines:
Line Access:
Line Assignment:
Line00N: unassigned
Trunk/Line Data:
Prime Set: First D/82 or D/42 extension number
For DID Trunk Lines:
Line Access:
Line Assignment:
<Trunk Line Number>: unassigned
Trunk/Line Data:
Line Type: public
Rec’d #: Target Line Number
If Busy: to prime
Primeset: PBX integration port
DID Target Line Programming Requirement (MICS only)
The following programming requirements are only required if:
• A DID trunk line is used with the Dialogic
®
PBX Integration Board
• The target line number is needed in the caller ID information
112