Filter
Top Products
4. PBX Systems
• XFER (transfer) must be programmed on Feature Key 38.
• MWI (Message Waiting Indication) mechanisms are different with
ROLM CBX 9006 (or ROLM integration on the Hicom 300) and ROLM
CBX 9005 PBX.
For ROLM CBX 9006 PBX or ROLM integration on the Hicom 300
For the ROLM CBX 9006 PBX or ROLM integration on Hicom 300, the
following programming requirements apply:
• DDS (speed dial) must be programmed on Feature Key 03 for the correct
message waiting “ON” feature access code, which is *59 (default, but is
dependent on the PBX setup. Consult the PBX administrator for the
correct feature access code) if you are using the ROLM integration on the
Hicom 300 or if you are using the ROLM CBX 9006 PBX. To program
this key on the ROLMphone:
1. Press PROG (Feature Key 20).
2. Then press Feature Key 03.
3. Dial *59 (or the correct PBX dependent Feature Access Code), and
press PROG again.
4. The phone display indicates “STORED” and message-waiting light
(or Mailbox indicator light) ON is now set for Feature Key 03.
• DDS (speed dial) must be programmed on Feature Key 04 for the correct
message-waiting OFF feature access code, which is #60 (default, but is
dependent on the PBX setup. Consult the PBX administrator for the
correct feature access code) if using the ROLM integration on the Hicom
300 or if you are using the ROLM CBX 9006 PBX. To program this key
on the ROLMphone:
1. Press PROG (Feature Key 20).
2. Then press Feature Key 04.
3. Dial #60 (or the correct PBX dependent Feature Access Code), and
press PROG again.
4. The phone display indicates STORED and message-waiting light (or
Mailbox indicator light) OFF is now set for Feature Key 04.
53