Emerson 540VDC Power Supply User Manual


 
Installation
21
5. Drill 2" (51mm) deep holes in prepared surface using the drill bit included in the kit per bolt
pattern described in Figure 149 - Floor mounting template. The setter rod should be used as a
depth gauge to ensure proper depth. The setter rod is marked with two circles indicating the
maximum and minimum hole depth allowed (see Figure 18).
If a hole is drilled too deep, refill the hole with debris to the achieve proper depth.
Figure 18 Checking hole depth
6. Insert four (4) drop-in concrete expansion anchors into drilled holes.
Figure 19 Inserting anchors
7. Tap anchors into drilled holes using hammer or mallet. When top of anchor is flush with
mounting surface, use setter rod to expand and secure.
Figure 20 Expanding anchors
2.05"
(52mm)
Concrete Floor
Depth Marks
Setter Rod (provided)
Insert anchor flush with floor .
Use hammer if required.
Strike with
hammer
to set plug
DISCONTINUED
PRODUCT