Filter
Top Products
All the text prints on the same line.
Set
Auto
line
feed to on in the default-settings mode so that the
printer adds a line-feed to each carriage return. See “Using the
Default-Settings Mode” earlier in this chapter.
The text prints an extra blank line between each text line.
Set Auto line feed to off in the default-settings mode so that
two line-feed signals are not sent. See “Using the
Default-Settings Mode” earlier in this chapter.
Line spacing is incorrect. Adjust the line-space setting with
your software.
The printed page length is not what you expected.
The page length setting may not match the length of the paper
loaded in the printer. Change the page length setting with your
software to match the paper you are using. When using
continuous paper, you can change the length in the default
settings mode.
When using an optional interface card, the printer does not print
or the printout is not what you expected.
The other interface may be selected by the Auto interface
selection feature. Set Auto interface selection to off in the
default settings mode; the DIP-switch setting on the optional
interface board then selects the interface.
You may be trying to use an interface card or cable with the
wrong specifications. Check the specifications to make sure
you can use the interface card or cable with this printer.
3-28
Using the Printer