Filter
Top Products
Using the AFDD Program
The AFDD program reverses the current diskette drive
assignments and resets the system. When you are done using the
reversed drive assignments, you can use the AFDD program
again to reassign the drives to their original configuration.
The AFDD program is provided with your system on the
Reference diskette. If you do not have a hard disk, insert your
Reference diskette in drive A and log onto drive A before you
enter the command to start the program.
If you have a hard disk drive, copy the file AFDD.EXE from your
Reference diskette onto your hard disk (if you have not already
done so); then you can run the program from there. See
Chapter 3 for more information.
To run the AFDD program, type the following at the MS-DOS
command prompt and press Enter:
AFDD
You see a message such as the following:
New Assign Present
Drive A:
1.44MB
<=
1.2MB
Drive B:
1.2MB
<=
1.44MB
(S)et and Reboot, Any other key to
abort ?
If you inserted the Reference diskette to run the AFDD program,
remove it now.
If you want to change the drive assignments, press S. The system
reboots and loads MS-DOS, and the new drive assignments take
effect. If you do not want to change the drive assignments, press
any other key.
4-8
Enhancing System Operations