Filter
Top Products
8.
Still holding up the subassembly, reach further back
underneath it and disconnect the two power supply cables
connected to the back right side of the main system board,
as shown below. Pull each of the connectors straight up. Do
not pull only on the cables.
power supply cables
9.
Lift the entire subassembly out of the computer and carefully
place it on your work surface.
If you are installing a drive, follow the instructions under
“Installing a Disk Drive in the Horizontal Position” on the
next page.
If you are removing a drive, see “Removing a Disk Drive
From the Horizontal Position” on page B-44.
Installing and Removing Disk Drives
B-33