Filter
Top Products
Note
Only a few, old software
packages require you to use the
SETVGA program.
Installing the utility
Follow these steps to install SETVGA:
1.
Run the VGA Driver Setup program on your Utility 1
diskette to copy the SETVGA utility to your hard disk.
From the Main Menu, select Utility programs.
Then select SETVGA
from the submenu. See “Using the
VGA Driver Setup Program” on page A-4 for instructions.
When Setup asks for the name of the drive and directory to
contain the utility file, you can either press Enter to use the
default directory or change the pathname to your utility
directory, if you already have one.
2.
After you have copied the SETVGA utility to your hard
disk, it is best to include the pathname for SETVGA and
other utilities in your AUTOEXEC.BAT file. See the next
section for instructions.
Adding SETVGA to the AUTOEXEC.BAT file
For convenience in accessing SETVGA, you can include a
pathname in your AUTOEXEC.BAT file. Follow these steps:
1.
At the MS-DOS command prompt in the root directory,
type the following and press Enter:
COPY AUTOEXEC.BAT+CON AUTOEXEC.BAT
2.
To set the path for the SETVGA utility, type the following
and press
Enter:
PATH C:\pathname\
A-60
Using the
VGA Utilities