Filter
Top Products
Setting the Run Time Parameters
The tests you select will run in the following manner unless
you change the run time parameters:
Q
Each test is performed one time (passbound)
Q
The program waits if an error occurs
Q
No errors are recorded to the printer, disk, or other device.
If
you want to change the default run time parameters, press
c5
F2
to move to the Run time parameters window. (Press
m
at any time to exit and return to the submenu of
diagnostic tests.)
The first run time parameter specifies the mode in which to run
the test. You see this prompt:
Testing mode: (T)imebound / (C)ontinuous /
(P)assbound ? P
In Timebound mode, the program runs the tests for the amount
of time you specify; press
[Tl
and then
[Enl#l.
In Continuous mode, the tests run until you interrupt them;
press
[cl
and
[Enbrl.
In Passbound mode, the program runs the tests the number of
times you specify. This is the default setting; press
[PI,
if
necessary, and
m
to select the mode.
The next option is:
Wait on error (Y/N) ? Y
Press [VI and
[Enlw3
if you want the program to pause when an
error occurs. This lets you view the error message, make note of
it, and then press
c3
~nbr
to continue. (Y is the default setting.)
B-4
Performing System Diagnostics