Filter
Top Products
Entering Keyboard Commands
You can change the processor speed by entering one of the
commands shown in the following table.
Speed setting commands
Numeric keypad commands Speed setting
I
33 MHz
I
To enter these commands, hold down the [key and the
[lutl
key simultaneously and then press the
m
or
m
key.
Use the
[+1
or
[-I
key on the numeric keypad.
Note
You can use the commands listed above while you are
running a program. However, if the program uses one of the
same commands for another function, you cannot use it to
change the processor speed. For example, if you are running
a program that uses the
[cbt
[‘[:I
command to move
the cursor, you cannot enter
[m
[Alt)
17
to change the
processor speed to slow. Another alternative is to use the
ESPEED program, described below.
The speed setting remains in effect until you press the
RESET
button or turn off the computer, or until you change it again
using the SETUP program, another keyboard command, or the
ESPEED program.
2-4
Enhancing System Operations